Cebora SPOT 3500 Manuel de service télécharger pdf (Page 6)

CEBORA S.p.A. 6

3.302.047 21/12/00

3 - MAINTENANCE

WARNINGS

ANY INTERNAL INSPECTIONS OR REPAIRS MUST BE CARRIED OUT BY QUALIFIED

PERSONNEL.

DISCONNECT THE POWER SOURCE FROM THE MAINS BEFORE PERFORMING

MAINTENANCE.

3.1 - Periodic inspection, cleaning.

Periodically remove any dirt or dust from the air vents to ensure smooth air flow, and thus

adequate cooling of the internal parts of the power source.

Check the condition of the output terminals, output and power supply cables of the power

source; replace if damaged.

Check the condition of the internal power connections and connectors on the electronic board;

if you find “loose” connections, tighten or replace the connectors.

3.2 - Sequence of operations (fig. 3.2.1).

The following sequence represents correct functioning of the machine. It may be used as a

guiding procedure for troubleshooting.

It must be carried out after each repair without any errors.

NOTE

q Operations preceded by this symbol refer to operator actions.

♦ Operations preceded by this symbol refer to machine responses that must occur following an

operator action.

3.2.1 - Power source commands and signals.

1 2 3 4 5 6 7 8 9 10 11 ... 17 18

Pas de commentaire

Cebora SPOT 3500 Manuel de service Page 6